Tag Archive | "MOSTAT"

Video #15, “Rick’s Pipe Dream” Magnetic Motor – Generator

Monday, May 10, 2010

15 Comments

This is the second in a series of three videos (#14, 15 and 16) describing and demonstrating my preferred “cat’s meow” magnet configuration. I show how, when operating the stator magnet 1.75 inches above the rotor magnets, movement of the MOSTAT (moving stator) is nearly effortless and yet the rotational forces are still quite good.

Continue reading...

Video #17, “Rick’s Pipe Dream” Magnetic Motor – Generator

Saturday, March 27, 2010

12 Comments

This video shows the 26+5/8″ diameter 3/4″ birch plywood flywheel ring which has been attached to the bike wheel, and a spin test is performed with the stator at full height above the rotor. The flywheel has some runout that throws the wheel off balance, which of course is a negative aspect that needs to [...]

Continue reading...

Video #11, “Rick’s Pipe Dream” Magnetic Motor – Generator

Wednesday, March 24, 2010

0 Comments

A continuation of stator arm demonstrations seen in Video #9 and 10, this video goes into further details and explanations regarding magnet interactions used to create rotational thrust.

Continue reading...

Video #14, “Rick’s Pipe Dream” Magnetic Motor – Generator

Tuesday, March 23, 2010

0 Comments

This is the first in a series of three videos describing and demonstrating my preferred “cat’s meow” magnet configuration.

Continue reading...

Video #13, “Rick’s Pipe Dream” Magnetic Motor – Generator

Monday, March 22, 2010

18 Comments

In this video I demonstrate how the stator arm can be readjusted for use in a position where the stator magnet is aligned across the wheel rim, and used to produce continuous rotational movement. I may have moved the stator magnet more than is actually necessary with this technique, since the movement required is only [...]

Continue reading...

Video #12, “Rick’s Pipe Dream” Magnetic Motor – Generator

Friday, March 19, 2010

15 Comments

A continuation of stator arm demonstrations seen in Videos #9, 10, and 11, this video goes into further details and explanations regarding magnet interactions used to create rotational thrust and completes the section regarding use of a stationary stator.

Continue reading...

Video #10, “Rick’s Pipe Dream” Magnetic Motor – Generator

Wednesday, March 17, 2010

13 Comments

A continuation of video #9, video #10 demonstrates motive rotational forces using the stator arm, and explains the magnet interactions in detail. For further information about the Pipe Dream Project, please visit the Pipe Dream website: rickspipedreamproject.uuuq.com

Continue reading...

Video #9, “Rick’s Pipe Dream” Magnetic Motor – Generator

Tuesday, March 16, 2010

0 Comments

A continuation of video #8, video #9 further describes the stator arm components, and how the stator arm is aligned with the rotor magnets. Angles and measurements are given.

Continue reading...

Video #16, “Rick’s Pipe Dream” Magnetic Motor – Generator

Monday, March 8, 2010

25 Comments

This video shows the same “cat’s meow” magnet configuration demonstrated in video #15, but here I lower the stator arm, from the previous 1.75 inch height above the rotor magnets, to a 1 inch gap. As can be seen, this dramatically increases the attraction and repulsion effects. The rotor quickly accellerates, after a few seconds, [...]

Continue reading...

Video #18, “Rick’s Pipe Dream” Magnetic Motor – Generator

Monday, March 8, 2010

25 Comments

My purpose in this video is to clear up a common misconception held by several viewers of my videos, which is that I should be employing some method in order to counter the effects of so-called “sticky points.” I start by once again explaining what a sticky point is, and demonstrate how this – as [...]

Continue reading...

Powered by WordPress Lab
Powered by Yahoo! Answers